Sensors

Click on Switch store to select the location where you are installing sensors.

Once the correct store is selected, click the Install New Device button to begin.

Select the equipment you plan to install the sensor in, there's also an option to manually add a piece of equipment if it's not included in the list.

Scan the QR code on the front of the sensor to link it to an asset in Ecotrak.

Optional Add a brief description of where the equipment is located to help someone find the equipment when it needs needs service. 

Follow the remaining steps until you receive the green check indicating that the install was successful. Repeat the above steps to add more sensors.

Click the Install New Device button from the store page click Manual Entry at the bottom of the equipment list

Select an equipment type. Equipment types are the general type of equipment you are installing in, you will have an option to enter a specific name and asset ID on the next page.  

Enter the Asset ID and Asset Name, this information should match information in Ecotrak

You can edit the location or re-assign the sensor to a different piece of equipment by clicking the Edit button. 

You can remove remove a sensor if you installed it by mistake or if the equipment is being remove from the location. Click the Edit button to remove the sensor.